Bluetooth interface communication
This program is very similar to the program for the serial interface and enables communication via the Bluetooth interface on the opensensor.
The jumpers J1 and J2 must be set on the opensensor board in order to use the Bluetooth interface.
The settings for the Terminal program e.g. Hyper Terminal are:
- Com port of your Bluetooth dongle
- 115200 bit/s
- 8 databits
- No parity
- 1 stopbit
- Flow-control: None
- Ascii settings: Send new line and show written characters locally
To test the program you can write the following commands and press enter:
- B - Turns the green LED on
- A - Turns the green LED off